Accommodation-space safety inspections
What is being checked
The inspector is checking whether planned safety inspections of accommodation and service spaces are performed by competent personnel, identify actual hazards and produce timely corrective action.
Ready onboard
0/6 completePractice questions
Answer aloud, then open the preparation point.
1What are the highest risks in accommodation and service spaces?
Identify current vessel-specific hazards, including wedged fire doors, overloaded sockets, combustible storage, blocked escape, grease accumulation and defective detectors.
2Show one finding from the last inspection.
Take the inspector to the location and trace immediate control, permanent action and verification.
3How are overdue findings escalated?
Apply the SMS priority and notification path, reassess risk and maintain compensating controls.
4How do you prevent checklist familiarity from hiding defects?
Rotate competent participants, vary the route, compare trends and require exact evidence rather than repeated tick marks.
5What recurring weakness has been identified?
Use accommodation inspection reports, fire patrols, PMS and defect register to show trend analysis and the preventive response.
Where an observation may arise
The checklist omitted significant hazards such as fire doors, escape routes, detectors, electrical appliances, galley, laundry, housekeeping, sanitary condition and prohibited equipment.
Records were completed without credible physical access or contained repeated identical entries.
The recorded inspection did not identify wedged fire doors, overloaded sockets, combustible storage, blocked escape, grease accumulation and defective detectors.
A deficiency lacked exact location, risk, immediate control or required action.
An item was marked closed although the condition remained or only a temporary repair existed.
Repeated findings in accommodation inspection reports, fire patrols, PMS and defect register were not recognised or escalated.
Master's practical note
Walk the latest inspection route with the report. If obvious defects are absent from the record, question the inspection method before adding more checklist items.
Equipment boundary and references
Equipment boundary: Safety inspections supplement, but do not replace, routine rounds, planned maintenance, statutory surveys or immediate hazard reporting.
References
- OCIMF SIRE 2.0 Question Library Part 1, Version 1.0, Question 5.8.6
- SOLAS Chapter II-2
- ILO Maritime Labour Convention 2006
Last reviewed: 2026-09-13